Virtual Valve Museum
Virtual Valve Museum | search: (use * for wildcard)
About the museumMuseum exhibitsUpdates, new exhibits etc.EquipmentSupporters
*DocumentsValves wanted!Valves for sale or for tradeLinks to other sites, suppliers etc.

CV2188 travelling wave amplifier

Size
This valve measures 423x65mm overall, 30mm across the body. The stem measures 13x323mm. It has an octal base with 4 pins fitted.

This is a travelling wave tube. It carries the internal markings LZN 11.J.W.

Heater voltage6.3V
Nominal heater current950mA
Nominal 1st anode voltage (a)1.3kV
Max 2nd anode and helix voltage (b)3.2kV
Nominal collector voltageVa2 + 0.05
Max cathode current18mA
Max 1st anode current500µA
Max 2nd anode and helix current4mA
Minimum pre-heating time120sec
Max output2W
Minimum bandwidth (c)1000MHz
Wavelength6.5 to 8.5cm
Focusing field300 oersteds
Amplification (d)(e)20dB
Minimum cold transmission loss32dB
Minimum air cooling4cu ft/min


(a): The first anode draws negligible current and may be supplied by a potentiometer connected between the helix supply and cathode.
(b): The optimum helix voltage for individual valves lies between 2.8 and 3.2kV
(c): Between 3dB power points
(d): With collector current of 14mA and helix voltage within ±20V of the optimum value
(e): for small signal levels; At maximum output it is approx 4dB lower.

PinFunction
1n/c
2Heater
3no pin
41st anode
5no pin
6no pin
7no pin
8Heater + cathode
SC2nd anode and helix
TCCollector

base view
CV2188
gun inside view collector

This file was last modified15:26:55, Tuesday September 02, 2014