Virtual Valve Museum
Virtual Valve Museum | search: (use * for wildcard)
About the museumMuseum exhibitsUpdates, new exhibits etc.EquipmentSupporters
*DocumentsValves wanted!Valves for sale or for tradeLinks to other sites, suppliers etc.

CV2262 magnetron

Size
This valve measures 197x185x90mm overall

Heater voltage (a)5.5V
Heater current1.37A
Nominal frequency range8500 to 9050MHz
Max mean input power (b)150W
Max frequency pulling figure15MHz
Typical operating conditions (c)
Peak anode voltage14kV
Peak anode current14A
Peak output power60kW


(a) The heater supply should be switched on for at least 3 minutes before HT is applied. Full heater power is required for starting only
(b) When operating, the magnetron must be air cooled so that the temperature of the block surface does not exceed 140°C
(c) These operating conditions apply for a pulse duration of 0.1µS and a pulse repetition rate of 3000 pps. The rate of rise of the voltage pulse must not exceed 140kV/µS.

Connector
Output
CV2262

Rear view Bottom view

This file was last modified11:36:43, Tuesday January 27, 2015