Virtual Valve Museum
Virtual Valve Museum | search: (use * for wildcard)
About the museumMuseum exhibitsUpdates, new exhibits etc.EquipmentSupporters
*DocumentsValves wanted!Valves for sale or for tradeLinks to other sites, suppliers etc.

CV314 reflex klystron

CV314 size The klystron measures 170x28mm. The cavity is 60mm across x 22mm deep. It weighs approx 300g.

Described as an Electron Beam Noise Generator, this is a selected and mondified CV35.

The valve carries the following markings:

The number 5742 is labelled on the glass beneath the reflector connector.

The output connector carries the number AP67748

The cavity carries the number 6065 (or 5909 or S909 if rotated!) on both the top disc seal and the top of the cavity assembly.

Heater voltage 4V nom.
Heater current 1.45A nom.
Max cathode beam current 1mA
Tuning range 9.8 to 10.2cm
Operating resonator voltage 2.1 to 2.3kV
Grid voltage 0V

The heater voltage is adjusted to give the 1mA beam current.

CV314

 

Pin Function
1 Grid
2 Heater
3,4,5,6 n/c
7 Heater
8 Cathode
TC Collector
The valve is produced from the CV35 by the addition of an output coupling loop and plug, Admiralty Pattern 67748. Each valve is selected and adjusted to give a noise output equal to within 0.25db to a zero level of noise, defined by means of standard reference values, when operated at midband (10cm) with a collector current of 600µA. The collector current is adjusted by varying the heater voltage. The noise output should then be proportional to the collector current and virtually constant over the tuning range.
CV314 top view CV314 bottom view
Top and bottom views of the klystron.

This file was last modified 15:48:16, Tuesday September 02, 2014